Filter results

48200 results

LED: sustainable, but above all maintenance-friendly

LED: sustainable, but above all maintenance-friendly In ten years' time all outside lighting will be LED LED uses less energy, the bulbs last for longer and even the fittings have a longer lifespan. Within a decade, all external lighting on campus will be LED. This is expected to make a big difference in terms of maintenance. The Kluyverpark in the southern part of the campus is the first location in which LED lighting is being used, in the lamp posts and ground spotlights. That started in 2015. The project was immediately used as a pilot to see which fittings are suitable. In the process attention was also paid to the electrotechnical aspects, in other words the electricity cables, voltages and the network load. The latter, in particular, caused a number of teething problems. For example, LED lighting uses more power when switched on and consequently causes a higher peak load on the power network, thereby activating the security mechanism in the power supply cabinets. The solution was to reduce the number of LED light fittings and lower the inrush current in the power supply cabinet. Solving the puzzle provided input for the further technical development required for the introduction of LED lighting across the rest of the campus. After the pilot had been completed a schedule of requirements was drawn up, as well as a technical manual showing how the LED lights had to be installed, up to the power cable. This paved the way for the broad use of LED lighting on the campus and it is now being used in lampposts at an increasing number of locations. Advantages of LED Conventional lights have to be replaced after two to five years. In theory, a LED light source should last as long as the fitting, around 20 to 25 years. A lamppost lasts for around 40 to 50 years. The expectation is that the lamp and the light fitting will only have to be replaced once during the lamppost's lifespan. A further benefit of LED lighting is the possibility of controlling it remotely using software, for example to monitor electricity consumption, to make it easy to increase or decrease brightness, or to change the colour of the lighting. Consequently LED not only saves energy, but also offers a social and sustainable solution in the form of a safer environment. Normally the campus is illuminated up to 5 lux but with LED there is enough capacity for 10 lux. As a result the light level can be adjusted as needed, for example in the case of events attended by a large number of visitors. In late 2018 dynamic dimming (dimming based on need) was introduced for the public lighting. LED ambition TU Delft's ambition is to replace all conventional lighting with LED lighting in the coming ten years. During any major reconstruction projects on campus everything will be converted. One example is the redevelopment of the public space in the Stevin Area behind the CEG faculty, where all the lampposts were converted to LED lighting. The expectation is that 75% of the conventional lighting can be replaced in three to four years. The rest will be replaced in the last six to seven years. LED CO2 reduction Replacing conventional lighting with LED will save 8,500 kg of CO2 on an annual basis. Over a decade, that amounts to a planned CO2 reduction of 85,000 kg. Once everything is converted to LED, the result is expected to be a 41% reduction in energy consumption and CO2 emissions.

Half Height Horizontal

TU Delft jointly wins XPRIZE Rainforest drone competition in Brazil

TU Delft jointly wins in the XPRIZE Rainforest competition in the Amazon, Brazil Imagine using rapid and autonomous robot technology for research into the green and humid lungs of our planet; our global rainforests. Drones that autonomously deploy eDNA samplers and canopy rafts uncover the rich biodiversity of these complex ecosystems while revealing the effects of human activity on nature and climate change. On November 15, 2024, after five years of intensive research and competition, the ETHBiodivX team, which included TU Delft Aerospace researchers Salua Hamaza and Georg Strunck, achieved an outstanding milestone: winning the XPRIZE Rainforest Bonus Prize for outstanding effort in co-developing inclusive technology for nature conservation. The goal: create automated technology and methods to gain near real-time insights about biodiversity – providing necessary data that can inform conservation action and policy, support sustainable bioeconomies, and empower Indigenous Peoples and local communities who are the primary protectors and knowledge holders of the planet’s tropical rainforests. The ETHBiodivX team, made of experts in Robotics, eDNA, and Data Insights, is tackling the massive challenge of automating and streamlining the way we monitor ecosystems. Leading the Robotics division, a collaboration between TU Delft’s Prof. Salua Hamaza, ETH Zurich’s Prof. Stefano Mintchev and Aarhus University’s Profs. Claus Melvad and Toke Thomas Høye, is developing cutting-edge robotic solutions to gather ecology and biology data autonomously. “We faced the immense challenge of deploying robots in the wild -- and not just any outdoor environment but one of the most demanding and uncharted: the wet rainforests. This required extraordinary efforts to ensure robustness and reliability, pushing the boundaries of what the hardware could achieve for autonomous data collection of images, sounds, and eDNA, in the Amazon” says prof. Hamaza. “Ultimately, this technology will be available to Indigenous communities as a tool to better understand the forest's ongoing changes in biodiversity, which provide essential resources as food and shelter to the locals.” . . . .

Students Amos Yusuf, Mick Dam & Bas Brouwer winners of Mekel Prize 2024

Master students Amos Yusuf, from the ME faculty (Mick Dam, from the EEMCS faculty and graduate Bas Brouwer have won the Mekel Prize 2024 for the best extra scientific activity at TU Delft: the development of an initiative that brings master students into the classroom teaching sciences to the younger generations. The prize was ceremonially awarded by prof Tim van den Hagen on 13 November after the Van Hasselt Lecture at the Prinsenhof, Delft. They received a statue of Professor Jan Mekel and 1.500,- to spend on their project. Insights into climate change are being openly doubted. Funding for important educational efforts and research are being withdrawn. Short clips – so called “reels” – on Youtube and TikTok threaten to simplify complex political and social problems. AI fakes befuddle what is true and what is not. The voices of science that contribute to those discussion with modesty, careful argument and scepticism, are drowned in noise. This poses a threat for universities like TU Delft, who strive to increase student numbers, who benefit from diverse student populations and aim to pass on their knowledge and scientific virtues to the next generation. It is, therefore, alarming that student enrolments to Bachelor and Master Programs at TU Delft have declined in the past year. Students in front of the class The project is aimed to make the sciences more appealing to the next generation. They have identified the problem that students tend miss out on the opportunity of entering a higher education trajectory in the Beta sciences – because they have a wrong picture of such education. In their mind, they depict it as boring and dry. In his pilot lecture at the Stanislas VMBO in Delft, Amos Yusuf has successfully challenged this image. He shared his enthusiasm for the field of robotics and presented himself as a positive role model to the pupils. And in return the excitement of the high school students is palpable in the videos and pictures from the day. The spark of science fills their eyes. Bas Brouwer Mick Dam are the founders of NUVO – the platform that facilitates the engagement of Master Students in high school education in Delft Their efforts offer TU Delft Master Students a valuable learning moment: By sharing insights from their fields with pupils at high school in an educational setting, our students can find identify their own misunderstandings of their subject, learn to speak in front of non-scientific audiences and peak into education as a work field they themselves might not have considered. An extraordinary commitment According to the Mekel jury, the project scored well on all the criteria (risk mitigation, inclusiveness, transparency and societal relevance). However, it was the extraordinary commitment of Amos who was fully immersed during his Master Project and the efforts of Brouwer and Dam that brought together teaching and research which is integral to academic culture that made the project stand out. About the Mekel Prize The Mekel Prize will be awarded to the most socially responsible research project or extra-scientific activity (e.g. founding of an NGO or organization, an initiative or realization of an event or other impactful project) by an employee or group of employees of TU Delft – projects that showcase in an outstanding fashion that they have been committed from the beginning to relevant moral and societal values and have been aware of and tried to mitigate as much as possible in innovative ways the risks involved in their research. The award recognizes such efforts and wants to encourage the responsible development of science and technology at TU Delft in the future. For furthermore information About the project: https://www.de-nuvo.nl/video-robotica-pilot/ About the Mekel Prize: https://www.tudelft.nl/en/tpm/our-faculty/departments/values-technology-and-innovation/sections/ethics-philosophy-of-technology/mekel-prize

New catheter technology promises safer and more efficient treatment of blood vessels

Each year, more than 200 million catheters are used worldwide to treat vascular diseases, including heart disease and artery stenosis. When navigating into blood vessels, friction between the catheter and the vessel wall can cause major complications. With a new innovative catheter technology, Mostafa Atalla and colleagues can change the friction from having grip to completely slippery with the flick of a switch. Their design improves the safety and efficiency of endovascular procedures. The findings have been published in IEEE. Catheter with variable friction The prototype of the new catheter features advanced friction control modules to precisely control the friction between the catheter and the vessel wall. The friction is modulated via ultrasonic vibrations, which overpressure the thin fluid layer. This innovative variable friction technology makes it possible to switch between low friction for smooth navigation through the vessel and high friction for optimal stability during the procedure. In a proof-of-concept, Atalla and his team show that the prototype significantly reduces friction, averaging 60% on rigid surfaces and 11% on soft surfaces. Experiments on animal aortic tissue confirm the promising results of this technology and its potential for medical applications. Fully assembled catheters The researchers tested the prototype during friction experiments on different tissue types. They are also investigating how the technology can be applied to other procedures, such as bowel interventions. More information Publicatie DOI : 10.1109/TMRB.2024.3464672 Toward Variable-Friction Catheters Using Ultrasonic Lubrication | IEEE Journals & Magazine | IEEE Xplore Mostafa Atalla: m.a.a.atalla@tudelft.nl Aimee Sakes: a.sakes@tudelft.nl Michaël Wiertlewski: m.wiertlewski@tudelft.nl Would you like to know more and/or attend a demonstration of the prototype please contact me: Fien Bosman, press officer Health TU Delft: f.j.bosman@tudelft.nl/ 0624953733